Mini Trigger
The BERU f1systems Mini Trigger allows convenient handheld
testing of the Gen2 TPMS. The Mini Trigger transmits a low
frequency 00k modulated signal which remotely triggers the
wheel sensor under test to transmit a datagram.
Mini Analyser
The BERU f1systems Mini Analyser tests the Gen2 TPMS wheel
electronics by receiving RF packet information and
transmits LF codes on demand from both a specified and
non-specified wheel electronic.
The Mini Analyser also integrates the functions of the BERU f1systems Mini Trigger while incorporating a visual display of received data. At a glance, the pressure, temperature, serial number and other data channels can be viewed enabling fast diagnostic of the system.
For users bypassing the automatic positioning system on their vehicle, position files can be downloaded via the RS232 port to either the TPMS ECU or TPMS software on the PC. For a small, light, portable and fast method of carrying out TPMS diagnostics, the BERU f1systems Mini Analyser provides the ideal tool for everyday testing and management.
TPMS hand held Analyser
The BERU f1systems TPMS Analyser is a portable hand-held
device that enables the testing of all functions of the
BERU Tyre Pressure Monitoring System (TPMS) components.
The integrated MQS or Modulo connector allows direct
connection to the vehicle loom for antenna performance
testing.
The programmable RF receiver inside the Analyser can be configured to allow passive or active antennas to be connected directly to the unit, this receiver (which is normally configured to constantly receive sensor datagrams of either 433 or 315Mhz) can also be used to simulate TPMS wheel sensors.
The internal Low Frequency (LF) circuitry permits the testing of LF Satellite Triggers and Gen 2 TPMS sensors, the Gen 2 sensor simulation mode identically emulating the responses to received LF commands as if it were a real sensor. All sensor parameters; pressure, temperature, operating mode etc can be individually adjusted and transmitted, alternatively one of 16 preset datagrams can be selected.
An internal 16-megabit internal Flash memory allows thousands of datagrams to be permanently stored for later analysis. The data being accessed by the RS232 interface, which is also used for firmware update. A Female SMA connector on the top of the unit is provided for connection to a ¼ wave whip antenna (supplied) or external diagnostic equipment.
Main Features
- Compatible with Gen 1 & Gen 2 Sensors
- Internal radio modem for HF transmission and HF reception of 315MHz and 433MHz signals with variable transmission power (-40dBm - 90dBm) and automatic frequency detection and switching
- Simultaneous reception of 433 or 315MHz sensors - 0000 or FFFF CRC
- Simulation of all sensor parameters
- LF transmission / reception
- Menu based operation
- Controllable HF head module for antenna selection (6 external and one internal antenna) and difference between active and passive antenna for 315MHz or 433MHz
- Internal buzzer to indicate reception of LF and HF TPMS datagrams
- RS232 Interface, through which all functions can be
accessed and the firmware updated
3m RS232 cable supplied - SMA connection for external ¼ wave whip antenna (supplied)
- Supplied with 110/240v Mains power supply
- Internal NiMH battery provides in excess of 6 hrs continuous operation (backlight extinguished)
- 3m RS232 lead for external control and software updates
- Highly visible dot-matrix display with switchable background lighting and contrast control.
- Custom 17 key membrane keypad
- Integral Tx LED which is illuminated during simulation of LF and RF signals
For more information
contact us.
Alternatively phone +44 (0) 1379 646216 to speak to a
specialist right away.